Krix Volcanix Bedienungsanleitung

Owner’s ManualTektonix and Volcanix

symptomPower LED - double flashing redPower LED - flashing redPower LED - flashing blueNo sound from subwoofer (Power LED is red)Minimal deep bass pro

Due to continued development specifications may change without notice.Volcanix: specificationsDriversBass DriverElectronicsAmplifier PowerAmplifier S/

krix.comKrix Loudspeakers Pty Ltd14 Chapman RoadHackham SA 5163AustraliaT 61 8 8384 3433F 61 8 8384 [email protected] Rev #10001Please read these im

2Congratulations on choosing Krixsetup in briefThe following setup procedure will help you achieve the best performance from your subwoofer:1. control

3controls and featuresUse the back/forward arrows to access the following menusVolumeAdjusts the subwoofer’s output level. Low PassAdjusts the point a

12V triggerWhen a 12V signal is a applied to the trigger input the subwoofer will switch on from standby and the red active LED will illuminate. Use a

In place of conventional mechanical potentiometers the signal processor utilises Microchip® laser trimmed digital potentiometers, this offers precisio

6The most ‘obvious’ position for your subwoofer is not always the bestThe bass produced by a subwoofer is omni-directional and very hard for your ears

7to AV receiverconnection & calibration - AV receiverconnection and defaults It is recommended that you use Line Level RCA connections for home th

Stereo Amplifier--speaker A output--3333speaker B outputto left speaker to right speaker Pre-out Main-inS

9advanced connection methodsone subwoofer - stereo connectionIf your receiver has a stereo L & R subwoofer output feature, connect both L & R